eSun ePA12 1.75mm 1kg Black
Only 9 left
Nylon for parts that wear: gears, hinges and fixings.
Compatibility and preparation
What do these mean?Prindi kohe pärast kuivatamist, hoia rulli kuivatuskapis.
Recommended settings
Only 9 left
Recommended settings
Print settings
Printer requirements
Drying and storage
Manufacturer laboratory material data. Final part properties depend on print settings, part geometry and the test method.
Source: ePA12 Technical Data Sheet, Nov.2021, Version 4.0
eSun ePA12 1.75mm 1kg Black — colour: Black.
Nylon is the engineering material for parts that move and wear. It is tough, slippery and durable — where PLA would snap and PETG would wear, nylon keeps going.
eSun has been making 3D printing materials since 2007 and is now one of the largest manufacturers in the world — which means consistent quality between batches and a wide colour range.
Best for
- Gears, rollers and bearing seats
- Hinges and clips that need to flex
- Industrial wear parts
Worth knowing
Nylon absorbs moisture faster than any other filament — a few hours in open air is enough to make prints porous and weak. Print straight after drying and keep the spool in a dry box. Finished parts absorb moisture too and grow softer and tougher over time.
Exact print settings, drying recommendation and printer requirements are in the specification table above.
Related products
Eesti
Latviešu