Prof. Lab PLA Matte 1.75mm 1kg Black
Only 5 left
Easy-to-print PLA for parts with a matte, low-gloss finish.
Compatibility and preparation
What do these mean?Dry the filament if it is brittle or the spool has been open for a long time.
Recommended settings
Only 5 left
Recommended settings
Print settings
Use these values as a starting point and prefer the manufacturer’s specific profile.
Printer requirements
Before purchasing, check that the printer and preparation meet all four requirements.
Prof. Lab PLA Matte 1.75mm 1kg Black — colour: black.
Prof. Lab PLA Matte is an easy-to-print, plant-based PLA filament. Its matte surface reduces glare and visually softens layer lines. Low warping and consistent extrusion also make it suitable for beginners.
The matte finish is especially well suited to models, decorative parts and display pieces where a calm, non-reflective surface is important.
Suitable for
- Decorative models and design objects
- Architectural models and prototypes
- Figurines and display pieces
- Low-gloss enclosures and organisers
Good to know
PLA can soften or deform above 60 °C, so it is not suitable for parts left in a hot car or exposed to direct sunlight for long periods.
Moisture in the filament can cause stringing, bubbling and uneven extrusion. Store opened spools in a sealed container with desiccant and dry the filament before printing when necessary.
The exact printing parameters, drying recommendations and printer requirements are listed in the specification table above.
Related products
Eesti